Specifications for Design of footings as per IS 456: 2000 Isolated footings are designed to sustain the applied loads, moments and forces and the induced reactions and to ensure that any settlement which may occur is as nearly uniform as ...
Discy Latest Articles
Different Failure Modes of Concrete Columns – Compression Members
Gopal MishraThere are three modes of failure of concrete columns (compression members) i.e. failure due to pure compression, combined compression and elastic instability. These modes of failures of concrete compression members are discussed.
Design of Rectangular Reinforced Concrete Beam
Madeh Izat HamakareemReinforced concrete beams are structural elements that designed to carry transverse external loads. The loads cause bending moment, shear forces and in some cases torsion across their length. Moreover, concrete is strong in compression and very weak in tension. Thus, ...
Design of Raft Foundations – Methods and Calculations
Gopal MishraDesign of Raft Foundations – Methods and Calculations According to IS – 2950:1965, the design criteria of raft footings are given below: The maximum differential settlement in foundation on clayey soils and sandy soils should not exceed 40mm and 25mm ...
DESIGN STEPS OF RCC MEMBER FOR SHEAR AND TORSION
Gopal MishraDesign of a reinforced concrete section for shear is carried on in the following steps: (a) Determine nominal shear stress of concrete by using following formula: (b) Determine design shear strength of concrete, (Table 1 below). Table-1: Design Shear Strength ...