A beam which is stiffened by a system of braces constituting a truss of which the beam is a chord is called trussed beam. It consists of steel sections (or wooden beams) and struts of steel rods. Trussed beams are ...
Discy Latest Articles
Fundamentals of Beam Design
The evolution of beam design, in the materials available for use and advancements in the understanding of their behaviour and physical properties, had made it possible to construct the architectural masterpieces of today. To appreciate these achievements the Engineer must ...
Design of Deep Beam-Spreadsheet
This spreadsheet is for the design of deep beams. It includes the following design steps:Design for area of steel for continuous/fixed deep beam – limit state designCheck for deep beam action, minimum thick.of beam to prevent buckling w.r.t span and ...
ENCASED BEAMS
ENCASED BEAMS When a steel beam is encased in cement concrete throughout the entire length, it is called an encased beam. The cased beam is shown in figure below. CODE STIPULATION: As per IS 800 :1984, beams may be designed ...
Theory of Simple Bending
When a beam is subjected to a loading system or by a force couple acting on a plane passing through the axis, then the beam deforms. In simple terms, this axial deformation is called as bending of a beam. Due to ...
Limit State, Working Stress and Ultimate Load Method of Structural Design
This was the traditional method of design not only for reinforced concrete, but also for structural steel and timber design. The method basically assumes that the structural material behaves as a linear elastic manner, and that adequate safety can be ...
Characteristics of Beams for Its Analysis and Design
There are a number of properties of a beam that an Engineer should be aware of as they dictate beam behaviour when subject to a load and ultimately represent possible areas or mechanisms for failure. The main ones being: Second moment ...