Poll Results
Please login to vote and see the results.
How to rectify the old cement pipeline leakage problem?
Do you need to remove the ads? Become VIP Member
Join TheConstructor to ask questions, answer questions, write articles, and connect with other people. When you join you get additional benefits.
Log in to TheConstructor to ask questions, answer people’s questions, write articles & connect with other people. When you join you get additional benefits.
Lost your password? Please enter your email address. You will receive a link and will create a new password via email.
Please login to vote and see the results.
How to rectify the old cement pipeline leakage problem?
BASAVARAJ nimbalakar
control the pipe leackage by using NiTo bond chemical
nikeetasharma
Some of the methods to repair the old cement pipeline leakage problem are :-
1. Clean the Floor :- Before using any concrete filler, make sure there’s no oil or dirt still on the floor. If there is, use a cleaner that cuts grease. This will help the filler bond to the cement.
Use a cold chisel and a hammer to get rid of any large pieces in the crack. Hold the chisel at an angle and pound with the hammer to chisel out the crack. This is called “keying” the hole to make the base or inside of the crack bigger than it is at the surface. Keying helps the new patching material bond with the old crack.
2. Brush and Vacuum Once you’ve keyed the crack, it’s important to clean up and get rid of dust and debris. Use a whisk broom then vacuum the crack thoroughly.
3. Spread Concrete Patch :- To use the concrete filler, cut the nozzle off the bottle and slowly fill the cracks (image 1). If you’re using mixed concrete patch, mix according to the manufacturer’s direction and thentrowel the patch into the crack (image 2). Check the cracks in a few minutes to see whether the filler has settled. You may have to add some more if it doesn’t look tight. Use a trowel to smooth out the cracks
4. Allow it to Cure :- Allow the filler to cure overnight or at least the duration recommended by the manufacturer. Then check it again to see if any additional patch is needed.
5. Seal the Patch and Concrete :- After patching the concrete, it’s a good idea to seal it. Concrete easily absorbs stains, and sealing will prevent that. There are more than a few products available for concrete sealing, but a heavy-duty water-based polyurethane is a good choice. If the floor has a rough finish, apply the polyurethane with a broom or brush using the bristles to work the sealer into the rough surface. With a smooth surface use a roller.
The beauty of water-based polyurethane is that it dries quickly, so you can put on a second coat just a few hours after the first. Also, water-based polyurethanes don’t smell as bad as other types of sealer. In heavy traffic areas, it’s a good idea to apply three or four coats.
Komal Bhandakkar
If you have a leaking pipe below your Foundation then it is either a water or sewer line. Repairing the damage the line is not too hard and difficult task however locating and giving asses to it is matters a lot. Once you locate the general area of the leak then you will have to cut and reason your way through the concrete to repair the pipes. There are several points to a slab leak. The presence of water is one of the main symptoms of leakage. The most commonly used type of pipe for water line under a slab Foundation is copper tubing. As copper pipe age then they are prone to wearing thin and springing a leak. Fixing a leaking sewer line may require the services of a plumber because of the types of pipes used for civil line and health-related issues involving exposure to human waste. Depending on the age of the home, the pipe may be cast iron, clay, or PVC. Special rubber couplings are ideal for connecting different types of pipes they are not recommended for use below concrete slabs.